Traditional phase sequence measurement methods must poke the three-phase wire terminal, and connect the three bare alligator clips or test pins of phase sequence meters to the three bare firing lines, while ETCR1000A uses clamp non-contact measurement, without taking off the wire and no need to contact high-voltage bare fire-wire, the test can be made by directly clamping the three-phase insulating sheath by three super-sensitive high-insulated clamps. Conducting measurement on sheathed cable significantly improves the safety of field testing, effectively protect the operator¡¯s personal safety and increase productivity!

In addition to phase sequence detection, it also has the functions of live wire examination, simple power detection, fire-wire identification, phase deficiency determination, break location detection, DC line break and line maintenance, equivalent to 3 induction electric pens.  

LED dynamic display, intuitive and clear

More sensitive ETCR1000A clamp, can even sense the AC voltage signal as low as a few Volts, with a wider range of live electricity.

The three clamps of ETCR1000A are in three colors, Red, Yellow and Blue; It is more in line with the distinction of three-phase line, and more scientific and artistic overall appearance.

 

ETCR1000A has a better power-saving performance with the maximum rated power of 100mVA

Phase detection (normal phase, reverse phase and phase deficiency), Live wire examination, Simple Power detection, Breakpoint location and Line maintenance.  

DC3V AA Mn batteries (R6P) ¡¿2 PCS, Continuously working for 200 hours

AC0¢¦600V, 40¢¦70Hz (Sine Wave Continuous Input)

Diameter ©ª18mm, Insulated wire available.(Equivalent to wire cross-sectional area 120mm²)

¡¼Positive phase¡½Four lights of phase detection rotate in Clockwise direction, with intermittent short beeps

¡¼Reverse phase¡½Four lights of phase detection rotate in counterclockwise direction, continuous beep

¡¼Live power¡½ R-S and S-T lights on within voltage setting range

¡¼Phase deficiency¡½R-S, S-T lights do not flash

¡¼Open circuit¡½R-S, S-T lights do not flash

Boot indication light turns on after booting

After 3 minutes, the meter automatically cut off power supply.

Width, height, thickness 70mm¡¿75mm¡¿30mm

0.5m

180g (with battery)

-10¡É¢¦55¡É; below 80%rh

-20¡É¢¦60¡É; below 90%rh

AC600V

5.4kVrms

100mVA

EN61010-1: 2001, EN61010-031: 2002, Pollution level 2, CAT ¥²(600V), Transient over-voltage 6000V

Meter: 1 Piece; Carrying case; 1 Piece.